Voltage divider
The same current flows through both resistors, so the supply voltage splits between them in proportion to their resistance. Take the output from the middle and you get a fixed fraction of the supply, until something draws current from it: add a load and watch the output sag.
The formulas
- Unloaded output: Vout = Vin × R2 ÷ (R1 + R2).
- With a load RL: it sits in parallel with R2, so use R2 ∥ RL = R2 RL ÷ (R2 + RL) in place of R2.
- Current and power: I = Vin ÷ (R1 + R2 ∥ RL); each resistor dissipates P = I² R.
- Output resistance: the divider behaves like a source of Vout behind R1 ∥ R2 = R1 R2 ÷ (R1 + R2). A load ten times that pulls the output down by 1 ÷ 11, about 9%.
Ideal resistors and an ideal supply (no internal resistance). A divider is fine for setting a reference or reading a sensor into a high-impedance input; it isn't a power supply, because the output falls as soon as the load draws real current. Tested: the output against Kirchhoff's current law at the output node, and power in equals power out, for loaded and unloaded dividers (packages/mechanics/test/science.test.ts).
Example
With supply 12 V, R1, top 10 kΩ, R2, bottom 4.7 kΩ, load on the output: none: output voltage: 3.837 V; without the load: 3.837 V; current from the supply: 816 µA; power in R1: 6.66 mW; power in R2: 3.13 mW; output resistance: 3.2 kΩ. Open this setup, then change one thing at a time.
Related: RC circuit · Torque to horsepower