Float valve (ballcock)

Water pushing the valve open
Float must push up
Shut-off

The rising water lifts the float, the arm swings and presses a washer over the inlet. The float stops rising with the arm, so the water keeps climbing up its sides until the extra buoyancy, multiplied by the lever, beats the water pushing through the hole.

The physics

If the float fully under water still can't beat the supply, the cistern overflows: the readout then gives the highest pressure this float can shut. Float and arm weigh 50 g in this model; water is 1000 kg/m³ and g = 9.81 m/s². Tested: the moments balance at the computed shut-off depth, and the sphere volume formula against slicing the sphere numerically (packages/mechanics/test/fluids.test.ts).

Example

With float diameter 110 mm, lever ratio (float arm ÷ valve arm) = 10, supply pressure 3 bar, inlet hole 3 mm: water pushing the valve open: 2.12 N; float must push up: 0.70 N; shut-off: float 21.9 mm under. Open this setup, then change one thing at a time.

Related: Will it float? · Check valve · Pressure relief valve